来源：www.wangerfu.com.cn
The biggest feature of this product is that there is no need to drill a hole in the wall tile, the use of seamless adhesive to fix anytime and anywhere, simple installation, will not cause damage to the beloved glass and tile wall, the hand is easy to install. Very thoughtful design
Stick firmly and remove without leaving a trace
When pulled up, neither residual glue nor damage the wall
Suitable for latex paint wall, tile surface, smooth and flat wallpaper surface, all kinds of lacquer furniture surface
Reusable with rubber strip
Note:
1, be sure to firmly press the back seat when pasting, and avoid the gap of the tile, so that the adhesive strip is completely adhered to the surface, in order to ensure its weight.
2, When removing, gently hold the left and right ends of the back seat of the hook, and slowly pull down the adhesive strip as close as possible to the surface, so as not to break the adhesive strip or damage the adhesive surface.
3, the load should not exceed the load limit listed on the package, and the load should be parallel to the direction of the wall as far as possible.
4, do not hang mirrors, wall clocks, glass photo frames, glass products, knives and other valuable or dangerous fragile items, do not hang items on the sitting or bed, so as to avoid the hook due to improper use of the risk of falling off.
5, do not use this hook in oil and wet places. Do not use on uneven and rough or porous surfaces, such as micro-pores or cracked latex paint surface, plastic wallpaper, earth wall, sand wall, patterned tile wall.
6, when used in the latex paint, the paint will fall off during hanging due to the aging, delamination, cracking, shortness and other reasons of the latex paint, which has nothing to do with the adhesion of the traceless hook. Please use it carefully in the latex paint.
7, the paste surface temperature is 10-40℃, the paste effect is best. When the surface temperature of the paste is too low or used on the surface of the tile, please use a hair dryer to gently heat the adhesive strip and the wall, and paste it while it is hot.
8, it is recommended to keep the room dry for 24 hours after installation.
